DIRECTIONS
Sand and fill the floor, removing all wax, oil or existing finish. After final sanding or screening, vacuum and tack thoroughly.
Mix the two components in the prescribed ratio and wait 10 minutes before applying, to allow prereaction.
Apply the sealer by pad, brush, roller or airless-spray. When dry, abrade and eliminate dust carefully.
Recoat with one of our solvent-based finishes of the V3a series, or else with our two-component waterborne finishes.
NOTICE
- Apply at a room temperature between +15° and +35° C with a relative humidity degree not over 70%. Allow product to reach room temperature before application.
- To optimize the coverage rate, we recommend using 4-mm-hair rollers.
- Always abrade the sealer before applying a waterborne finish.
Dispose of excess product and empty containers properly.
If the original unopened containers are stored in a cool and dry place, the product will keep for at least 12 months.
